Valve gate nozzle
Elements for XINTECH Hotrunner System
||XINTECH heating elements
guarantee a flow channel of the plastic mass from machine nozzle to
injection point without any thermal interruption. The special heaters
presenting no "cold ends" enable even processing of delicate
technical materials like PEI, PET, PES or PA66 under industrial
conditions without compromise.
XINOX cartridge heaters fulfill all demands
regarding cyclic temperature control of plastic materials. The measuring point
with only 1mm diameter is placed outside of the cartridge heater, which means
that the point measures almost exclusively the temperature of the flowing
material. It ensures a steady temperature control also at a short cycle time.
Thermal damages of standing material (which are usual in case of conventional
cartridge heaters with a temperature profile that depends on the cartridge
length) are prevented due to a) the special way of spiral winding and b) the
absence of the so-called "cold ends".
XINOX ring heaters
The special insulation and the stainless cover ensures the
minimum thermal influence on the mould plates. In case of an extremely long
heating zone, a several ring heaters (if needed with sensors) can be brought
into one compact heating element. The base material is break-proof and has a
good thermal conductivity.
heating system; proved in rough daily use, reliable, easy maintenance. The
thermal conditions of a well-balanced hot runner system are calculated for this
heat transmission of the steel to be heated and the necessary heat quantity
which varies during the process phases are took into consideration at the
production for each application.
XINHEAT guarantees a proportional, linear and
energy-saving thermal control.
| back to "Hotrunner system" | main menu